Roundcube Community Forum

 

[0.3.1] Unable to login after upgrade

Started by zerovice, December 15, 2009, 07:01:15 PM

Previous topic - Next topic

zerovice

I upgraded from 0.2 to 0.3.1 manually and am having a curious issue.  I used the installer via the web.

I log in successfully as seen in /var/log/maillog

Dec 15 18:52:28 dovecot: imap-login: Login: user=, method=PLAIN, rip=127.0.0.1, lip=127.0.0.1, TLS
Dec 15 18:52:28 dovecot: IMAP(testuser): Disconnected: Logged out bytes=8/306

and am sent to this page

http://.../wm/?_task=mail

although am only presented with the login page again.

Setting the debug level to 13 all I receive in output is the following which seems fine, afaict.

* OK [CAPABILITY IMAP4rev1 LITERAL+ SASL-IR LOGIN-REFERRALS ID ENABLE AUTH=PLAIN] Dovecot ready. AUTH PLAIN: Resource id #42

Thanks for any assistance...

zerovice

So, I think I posted this in the incorrect forum. Please move this to General Discussion if possible. I have also opened  Ticket #1486373. Thanks!

zerovice

In the Bug Ticket it was recommended that the debug_level be changed to 1 and review the logs. Unfortunately, there were no logs created when reproducing. Logs are functional as if I set sql, imap, and userlogin to true I get a log for each of them in my logs/ dir.

Not sure where to go next...

SKaero

Does this happen with a fresh install on the SVN?

zerovice

Brilliant! So there is a bug somewhere... Installing trunk and running through the installer gets me in just fine. I'll update Ticket #1486373. Once root cause has been identified if it is ever then I'll update here. Otherwise, anyone looking at this thread I would recommend you viewing #1486373 (Unable to login after upgrade) ? Roundcube Webmail before giving up as there may be a resolution there.

SKaero

The SVN is the latest development version so if it was a bug it has already been fixed, however it is most likely a error from when you upgrading.

sagvokrage